Heath Zenith Work Light SL 4180 84 A User Manual

T
®
OPERATION  
Mode:  
Test  
On-Time  
Works: Day Night  
Dual Brite™  
Motion Sensing  
5 Sec  
x
x
x
x
x
Auto  
1, 5 or 10 Min  
To Dawn*  
Manual  
Coach Light  
Accent 3,6 Hr, to Dawn  
Models SL-4180/84 - A  
* resets to Auto Mode at dawn.  
For TEST  
Features  
• Light comes on when motion is detected.  
• Automatically turns light off.  
• Dusk Accent lighting.  
Set the ON-TIME switch  
onthebottomofthe cover  
TEST 1 5 10 MIN  
plate to TEST.  
For AUTO  
• Photocell keeps the light off during day-  
light hours.  
Set ON-TIME switch to 1,  
5 or 10 minutes.  
This package includes:  
TEST 1 5 10 MIN  
Mounting screws  
and wire  
For MANUAL OVERRIDE  
Flip the light switch off for  
one second then back on.  
connectors  
Manual override works  
when the ON-TIME switch  
is in any position.  
1 Second OFF  
then...  
Tail Assembly  
(Lantern & Coach)  
Manualoverrideonlyworks  
at night because daylight  
returnsthesensortoAUTO.  
Grand  
Manor  
Candelabra  
or  
... back on.  
Requirements  
Mode Switching Summary  
• The Light Control requires 120 volts AC.  
• If you want to use Manual Override, the  
control must be wired through a switch.  
Some codes require installation by a  
qualified electrician.  
ON-TIME  
TEST  
Switch at  
1, 5 or 10  
minutes  
Turn  
light  
AUTO  
Flip light  
switch  
off for 1  
second  
then on  
switch  
off for 10  
seconds  
then  
Questions? Call 1-800-858-8501  
8:00 AM to 4:45 PM Eastern Time,  
weekdays.  
MANUAL OVERRIDE  
back on*  
* Wait one minute for sensor to warm up.  
Lo sentimos, pero no podemos contestar  
preguntas en español por teléfono.  
Dusk Accent Mode  
Light comes on half bright for selected time  
after dusk (Off, 3 hr., 6 hr., until dawn). If  
motion is sensed, the light turns on full bright  
for the ON-TIME (1, 5 or 10 minutes) then  
returns to dim mode.  
© Heath Company  
Printed in Hong Kong  
595-5578  
 
The detector is less sensitive to motion  
directly towards it.  
Adding Decorative Tail  
2. Screw  
in exten-  
sion bar.  
Motion  
Motion  
3. Add tail  
piece and  
trim.  
1. Remove  
decorative nut  
from bottom of  
fixture.  
Sensor  
4. Screw  
decorative  
nut back on.  
Least Sensitive  
Most Sensitive  
Walkthroughthecoverageareanoting  
where you are when the lights turn on.  
Rotate the sensor head (maximum 0f  
45°leftorright)tochangethecoverage  
TESTING  
Turn on the circuit breaker and light  
switch. There is a one minute warm-up  
beforethesensorwilldetectmotionprop-  
erly.  
area.  
45°  
240°  
Switch the on-time to TEST position  
and Dual Brite™ switch to the off posi-  
tion.  
90°  
45°  
Maximum Sensor  
Rotatation  
Maximum Aiming  
Range  
Set the amount of TIME you want the  
light to stay on after motion is detected.  
OFF  
3
6
DUSK TO  
DAWN  
TEST 1 5 10 MIN  
HOUR  
Avoid aiming the control at:  
OFF  
3
6
DUSK TO  
DAWN  
TEST 1 5 10 MIN  
HOUR  
Pools of water or objects that change  
temperature rapidly, such as heating  
vents and air conditioners. These heat  
sources could cause false triggering.  
• Areas where pets or traffic may trigger  
the control.  
Nearby large, light-colored objects re-  
flecting daylight may trigger the shut-off  
feature. Do not point other lights at the  
Set the amount of time after dusk you  
want the lights on accent level.  
SPECIFICATIONS  
Range . . . . . . . . . . . Upto30feet(variesduring  
daylight hours).  
Sensing Angle . . . . . Up to 150°, 240° aimable  
Electrical Load. . . . . (3) 60 W. candelabra,  
400W (3.3 A.) total  
sensor.  
150°  
Power Requirements 120 VAC, 60 Hz  
Operating Modes. . . TEST, AUTO and  
MANUAL OVERRIDE  
Time Delay . . . . . . . 1 , 5, 10 minutes  
Accent timer . . . . . . Off, 3, 6 Hrs, to dawn  
6 ft.  
Sensitivity . . . . . . . . Adjustable  
30 ft.  
The Heath Company reserves the right to discontinue  
products and to change specifications at any time  
without incurring any obligation to incorporate new  
features in products previously sold.  
Maximum  
Range  
Maximum  
Coverage Angle  
 
TROUBLESHOOTING GUIDE  
If you experience a problem, follow this guide. If the problem persists, call the  
assistance at 1-800-858-8501 8:00 AM and 4:45 PM EST weekdays.  
Lo sentimos, pero no podemos contestar preguntas en español por teléfono.  
POSSIBLE CAUSE  
SYMPTOM  
POSSIBLE CAUSE  
SYMPTOM  
1. Light switch is turned off.  
2. Bulbislooseorburnedout.  
3. Fuse is blown or circuit  
breaker is turned off.  
4. Daylightturn-offisineffect  
(recheck after dark).  
5. Incorrect circuit wiring, if  
this is a new installation.  
6. Re-aimthesensortocover  
desired area.  
Light will not  
come on.  
1. The sensor is pointed at  
nearby objects that cause  
heat to trigger the sensor.  
(Aimthesensorawayfrom  
nearby objects.)  
2. The sensor is pointed  
toward a heat source like  
an air vent, dryer vent, or  
brightly-painted heat-  
reflectivesurface.(Re-aim  
sensor.)  
Light stays on  
continuously.  
Light comes  
on in day-  
light.  
1. Light Control may be in-  
stalled in a relatively dark  
location.  
2. Light Control is in Test. (Set  
control switch to an ON-  
1. Heatbeingreflectedfrom  
other objects may be  
affectingthesensor.(Re-  
aim sensor.)  
2. LightControlisintheTest  
mode and warming up.  
(Flashingisnormalunder  
these conditions).  
Light flashes  
on and off.  
TIME position.)  
1. Light Control may be sens-  
Light comes  
on for no  
apparent  
reason.  
ingsmallanimalsorautomo-  
bile traffic (re-aim sensor).  
2. Sensitivity is set too high.  
(Reduce sensitivity.)  
YOUR HEATH ZENITH FIVE YEAR LIMITED WARRANTY  
This is a “Limited Warranty” as defined in the U.S. Consumer Product Warranty and Federal Trade  
CommissionImprovementAct. Thiswarrantygivesyouspecificlegalrights, andyoumayalsohave  
other rights which vary from state to state.  
For a period of five years from the date of purchase, any malfunction caused by factory defective  
partsorworkmanshipwillbecorrectedatnochargetoyou. Lightbulbsarenotcovered.Toobtain  
a refund or a replacement, return the product to the place of purchase.  
Not Covered — Repair service, adjustment and calibration due to misuse, abuse or negligence,  
light bulbs and other expendable items are not covered by this warranty. Unauthorized service or  
modification of the product or of any furnished component will void this warranty in its entirety. This  
warranty does not include reimbursement for inconvenience, installation, set-up time, loss of use,  
or unauthorized service.  
ThiswarrantycoversonlyHeathZenithassembledproductsandisnotextendedtootherequipment  
and components that a customer uses in conjunction with our products.  
SUCH REPAIR OR REPLACEMENT SHALL BE THE SOLE REMEDY OF THE CUSTOMER AND  
THERE SHALL BE NO LIABILITY ON THE PART OF HEATH FOR ANY SPECIAL, INDIRECT,  
INCIDENTAL, OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO ANY  
LOSS OF BUSINESS OR PROFITS, WHETHER OR NOT FORESEEABLE. Some states do not  
allow the exclusion or limitation of incidental or consequential damages, so the above limitation or  
exclusion may not apply to you.  
 

Grizzly Drill 1008 User Manual
Grizzly Trimmer G8120 User Manual
Hans Grohe Plumbing Product 38830XX1 User Manual
Harbor Freight Tools Nail Gun 68024 User Manual
Heath Zenith Home Security System SL 9525 User Manual
Hotpoint Refrigerator 8591 User Manual
Hunter Fan Noise Reduction Machine 22691 User Manual
Husqvarna Lawn Mower YTH2146XP User Manual
IBM Laptop GC28 1982 02 User Manual
Icom Marine Radio IC F9511HT User Manual