Honeywell Weather Radio 08060 TH106 TL6061 69 2024 User Manual

08160  
TH106  
TL6160  
1.  
NOTE: Always keep the thermostat's vents clean and unobstructed.  
Description  
n
n
This programmable thermostat can be used to control an electric  
heating system such as an electric baseboard heater, a radiant ceil-  
ing, a radiant floor, a convector, etc.  
Temperature  
preset buttons  
Appears when the  
setpoint is displayed  
Time and day  
Temperature  
Set the day  
Set the time  
Operating  
mode icons  
o Connect the thermostat wires to the line wires and to the load  
Program the  
schedule  
wires using solderless connectors for copper wires.  
Temperature  
preset icons  
Skip a period  
Heating power  
indicator  
Select the  
operating mode  
Periods  
2-wire installation  
Temperature  
adjustment  
buttons  
The thermostat cannot be used under the following conditions:  
The resistive load is greater than 16.7 A  
The resistive load is less than 2 A  
The system is driven by a contactor or relay (inductive load)  
The system is a central heating system  
4-wire installation  
SUPPLIED PARTS:  
One (1) thermostat  
Two (2) 6-32 screws  
Two (2) solderless connectors  
2.  
Installation  
o
TURN OFF POWER TO THE HEATING SYSTEM AT THE MAIN  
POWER PANEL TO AVOID ELECTRICAL SHOCK.  
p Push any excess wire back into the electrical box.  
THE INSTALLATION MUST BE PERFORMED BY AN ELECTRI-  
CIAN.  
All cables and connections must conform to the local electrical  
code.  
Special CO/ALR solderless connectors must be used when con-  
necting with aluminum conductors.  
Install the thermostat onto an electrical box.  
Install the thermostat about 5 feet high, on an inside wall facing  
the heater.  
Avoid locations where there are air drafts (such as the top of a  
staircase or an air outlet), dead air spots (such as behind a  
door), or direct sunlight.  
NOTE: If necessary, before re-installing the front component, config-  
ure the thermostat (see section 3).  
Do not install the thermostat on a wall that conceals chimney or  
stove pipes.  
q Return power to heating system.  
The thermostat wires are not polarized; either wire can be con-  
nected to the load or to the power supply.  
08060 / TH106 / TL6061  
69-2024  
1/11/06  
1/3  
Programmable Thermostat - Installation and User Guide  
 
11.  
r Press Mode to exit the programming mode.  
NOTE: If no button is pressed for 60 seconds, the thermostat will  
automatically exit the programming mode.  
Warranty  
;
Honeywell warrants this product, excluding battery, to be free from  
defects in the workmanship or materials, under normal use and ser-  
vice, for a period of one (1) year from the date of purchase by the  
consumer. If at any time during the warranty period the product is  
determined to be defective or malfunctions, Honeywell shall repair or  
replace it (at Honeywell's option).  
If the product is defective,  
(i) return it, with a bill of sale or other dated proof of purchase, to  
the place from which you purchased it, or  
8.  
Power Outage  
In the event of a power outage, most settings are saved. Only the  
u
time must be re-adjusted if the power outage lasts more than 2 hours.  
The thermostat will return to the mode that was active prior to the  
power outage.  
9.  
(ii) call Honeywell Customer Care at 1-800-468-1502. Customer  
Care will make the determination whether the product should be  
returned to the following address: Honeywell Return Goods,  
Dock 4 MN10-3860, 1885 Douglas Dr N, Golden Valley, MN  
55422, or whether a replacement product can be sent to you.  
This warranty does not cover removal or reinstallation costs. This  
warranty shall not apply if it is shown by Honeywell that the defect or  
malfunction was caused by damage which occurred while the prod-  
uct was in the possession of a consumer.  
Honeywell's sole responsibility shall be to repair or replace the prod-  
uct within the terms stated above. HONEYWELL SHALL NOT BE  
LIABLE FOR ANY LOSS OR DAMAGE OF ANY KIND, INCLUDING  
ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING,  
DIRECTLY OR INDIRECTLY, FROM ANY BREACH OF ANY WAR-  
RANTY, EXPRESS OR IMPLIED, OR ANY OTHER FAILURE OF  
THIS PRODUCT. Some states do not allow the exclusion or limitation  
of incidental or consequential damages, so this limitation may not  
apply to you.  
THIS WARRANTY IS THE ONLY EXPRESS WARRANTY HONEY-  
WELL MAKES ON THIS PRODUCT. THE DURATION OF ANY  
IMPLIED WARRANTIES, INCLUDING THE WARRANTIES OF  
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PUR-  
POSE, IS HEREBY LIMITED TO THE ONE-YEAR DURATION OF  
THIS WARRANTY. Some states do not allow limitations on how long  
an implied warranty lasts, so the above limitation may not apply to  
you.  
Troubleshooting  
v
PROBLEM  
SOLUTIONS  
This condition is normal. Under normal  
operation, the thermostat housing can  
reach a temperature between 95 °F  
(35 °C) and 104 °F (40 °C).  
Thermostat is hot.  
The measured temperature is below the  
display range. Heating is activated.  
LO is displayed.  
HI is displayed.  
The measured temperature is above the  
display range.  
Wrong temperature is  
displayed.  
The thermostat is exposed to air draft.  
Eliminate the draft.  
The thermostat was without power for  
more than 2 hours.  
Wrong time is displayed.  
Temperature does not  
Check that the thermostat is in Automatic  
change according to the mode. Check the schedule and clock set-  
programmed schedule. tings.  
The thermal protection device on the  
Display disappears and  
heater is open. This can happen after a  
reappears after a few  
power failure or if the heater is obstructed  
minutes.  
by furniture or curtains.  
Display looks faded  
when heating is acti-  
vated  
The heating system is less than the  
required minimum load. This thermostat  
cannot be used below that rating.  
This warranty gives you specific legal rights, and you may have other  
rights which vary from state to state.  
10.  
If you have any questions concerning this warranty, please write Hon-  
eywell Customer Relations, 1985 Douglas Dr, Golden Valley, MN  
55422 or call 1-800-468-1502. In Canada, write Retail Products  
ON15-02H, Honeywell Limited/Honeywell Limitée, 35 Dynamic Drive,  
Technical Specifications  
w
Power: 120/208/240 VAC, 60 Hz  
Minimum load: 2 A (resistive only)  
250 W @ 120 VAC  
Scarborough, Ontario M1V4Z9.  
12.  
400 W @ 208 VAC  
500 W @ 240 VAC  
Customer Assistance  
Maximum load: 16.7 A (resistive only)  
2000 W @ 120 VAC  
If you have any questions about the operation of your thermostat,  
please go to http://yourhome.honeywell.com, or call Honeywell  
Customer Care toll-free at 1-800-468-1502.  
3500 W @ 208 VAC  
4000 W @ 240 VAC  
Display range: 32 °F to 140 °F (0 °C to 60 °C)  
Display resolution: 1 °F (0.5 °C)  
®
As an ENERGY STAR partner, Honeywell has  
determined that this product meets the ENERGY STAR  
guidelines for energy efficiency.  
Setpoint range: 40 °F to 86 °F (5 °C to 30 °C)  
Setpoint interval: 1 °F (0.5 °C)  
Storage: -4 °F to 120 °F (-20 °C to 50 °C)  
Certification: c UL us  
08060 / TH106 / TL6061  
69-2024  
1/11/06  
3/3  
Programmable Thermostat - Installation and User Guide  
 

Hampton Bay Outdoor Ceiling Fan 170 721 User Manual
Harbor Freight Tools Air Compressor 92699 User Manual
Harbor Freight Tools Automobile Parts 91039 User Manual
Honeywell Laptop VX8 User Manual
Hotpoint Cooktop GW81 User Manual
Hotpoint Oven SH53CX User Manual
Hotpoint Ventilation Hood LI2JDA User Manual
Huffy Fitness Equipment MCM108DB User Manual
Humax Satellite TV System CI 5100X User Manual
IKEA Indoor Furnishings AA 173212 3 User Manual